This is one of the nicest floor stands on the market. Solid oak finished with a clear finish so the beauty of the wood shows through, this is lovely enough to sit in your living room. Add your beautiful work and it’s a show piece.

Rhonda working on the stand with Lavella looking on.

This stand is perfect for scroll rods with a special support piece to give maximum performance.

Scroll Rod support bars adjust for just the right stitching angle.

This detail photo shows both the support system and the adjusting slots.

This closeup shows the range available in angle adjustment.

The Clamp system is perfect for either Stretcher Bars or Q-Snaps.

Clamp system will adjust for frames up to 29" standard. A cross bar allowing wider bars is available special order.

Side clamps hold Q-Snaps as well.

In addition to the width adjustments, this stand allows for height adjustments. I’m short so you wouldn’t want to stitch on a stand that works for me. This stand works for every height requirement, adjusting in 1″ increments.

Easily adjusted by moving the bolt alignment. A few twists on the wing nut and you're ready to stitch!

The feet on this stand are designed for stability, no tipping when you raise your piece to finish off the threads!

Feet are 16" long by 2-1/2" high and 31" apart for stability.

This is the last floor stand you’ll need to buy. It’s built for stitching convenience with materials that will last a lifetime. See how to order here.